LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2022 >> Trax LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions >> Repair Instructions >> Fuel Feed Intermediate Pipe Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Fig 1: Identifying Fuel Feed Intermediate Pipe Components
    GM3682444Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

    NOTE:

    High pressure fuel feed pipes are one time use only. ALWAYS install a NEW high pressure fuel feed pipe if the pipe is removed OR the fittings are loosened.

    To install the NEW fuel feed intermediate pipe (4) to the fuel injection fuel rail (1) and to the fuel pump (6), perform the following steps:

    1. Hand tighten the fuel feed intermediate pipe fitting (2) to the fuel injection fuel rail (1).
    2. Hand tighten the fuel feed intermediate pipe fitting (5) to the fuel pump (6).
    3. Tighten the fuel feed intermediate pipe fittings (2, 5) to 30 N.m (22 lb ft).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the fuel injection fuel feed pipe clip bolt (3) and tighten to 10 N.m (89 lb in).
  3. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9) , or Battery Negative Cable Disconnection and Connection (with KL9)
  4. Inspect for leaks using the following procedure:
    1. Turn ON the ignition with the engine OFF for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition with the engine OFF.
    4. Inspect for fuel leaks.
  5. Install the charge air cooler outlet air hose to the throttle body. Charge Air Cooler Outlet Air Hose Replacement
  6. Intake Manifold Cover - Install - Intake Manifold Cover Replacement
scientia non olet · About LEMON Manuals