Installation Procedure
- NOTE:
Some components not shown for graphic clarity.
Gear Shift Control Module (2) - Install
- Automatic Transmission Electronic Control Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connector. (3)
Instrument Panel Steering Column Lower Trim Cover (1) - Install
Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten - Fastener Specifications
Turn the steering wheel approximately 90 degrees to the right of the centered position.
- Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten - Fastener Specifications
Turn the steering wheel approximately 90 degrees to the left of the centered position.
- Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten - Fastener Specifications
- Turn the steering wheel to the centered position.
- NOTE:
Some components not shown for graphic clarity.
Connect the electrical connector. (1)
Secure the instrument panel steering column upper trim cover (1) to the instrument panel steering column lower trim cover.
- Perform the necessary programming and setup procedure: Control Module References
CAUTION:
Refer to Fastener Caution .