Removal Procedure

NOTE:

Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Open the hood.
Air Inlet Grille Panel - Remove - Air Inlet Grille Panel Replacement
Inside Rearview Mirror - Remove - Inside Rearview Mirror Replacement
Cover to protect the following parts from broken glass:
- Upper Dash Pad
- The defroster outlets and A/C outlets
- The seats and carpeting
Remove the lower windshield supports from the cowl panel, if equipped.
Courtesy of GENERAL MOTORS COMPANY

Using the appropriate tool, carefully cut around the lace (1), start in the center working from side to side of the window to access the urethane adhesive bead, if equipped.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Keep the cutting edge of the tool against the window.

This will allow the urethane adhesive to be separated from the windshield.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- Use commercially available glass cutting tool.
Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, remove the windshield (1) and locating pin (2) from the vehicle.