Installation Procedure
Inspect the inside of the ignition coil boot for a thin, even coat of dielectric grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease to the inside of the ignition coil boot up to a depth of 15 mm (0.60 in) from the end of the boot. Adhesives, Fluids, Lubricants, and Sealers
- Remove any excess dielectric grease from around the end of the ignition coil boot and ensure there is not an excessive amount within the boot.
- Ignition Coil (2) - Install [3x]
- Ignition Coil Bolt (1) - Install and tighten [6x] - Fastener Specifications
- Connect the electrical connectors.
Intake Manifold Cover (3) - Install
- Oil Filler Cap Seal (2) - Install
- Oil Filler Cap (1) - Install
CAUTION:
Refer to Fastener Caution .