Removal Procedure

WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the 2 covers (1).
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Airbag Bolt (1) - Remove [2x]
Release the connector position assurance (CPA) retainer.
Disconnect the electrical connector.
Steering Wheel Airbag (2) - Remove
Inflatable Restraint Module Handling and Scrapping
Courtesy of GENERAL MOTORS COMPANY

Release the retainers with a suitable plastic trim tool.
Steering Wheel Spoke Lower Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors.
Heated Steering Wheel Module (1) - Remove