Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

1. Ignition ON. Ensure the K183 UHF Short Range Low Energy Remote Control Access Transceiver, DLC and programming tool connections are secure and the SPS software is up to date.
2. Verify the module can be reprogrammed.
   • If the K183 UHF Short Range Low Energy Remote Control Access Transceiver cannot be reprogrammed 
   1. Ignition OFF for one minute, ignition ON.
   2. Verify the K183 UHF Short Range Low Energy Remote Control Access Transceiver can be reprogrammed.
      • If the K183 UHF Short Range Low Energy Remote Control Access Transceiver cannot be reprogrammed, replace the module.
      • Go to next step: If the K183 UHF Short Range Low Energy Remote Control Access Transceiver can be reprogrammed.
   3. All OK.
   • Go to next step: If the K183 UHF Short Range Low Energy Remote Control Access Transceiver can be reprogrammed 
3. All OK.