Installation Procedure
- NOTE:
Some components not shown for graphic clarity.
Gear Shift Control Module (2) - Install
- Automatic Transmission Electronic Control Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connector. (3)
Instrument Panel Steering Column Lower Trim Cover (1) - Install
Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten - Fastener Specifications
Turn the steering wheel approximately 90 degrees to the right of the centered position.
- Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten - Fastener Specifications
Turn the steering wheel approximately 90 degrees to the left of the centered position.
- Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Install and tighten - Fastener Specifications
- Turn the steering wheel to the centered position.
Secure the instrument panel steering column upper trim cover (1) to the instrument panel steering column lower trim cover.
- Program the gear shift control module. Control Module References
CAUTION:
Refer to Fastener Caution .