Removal Procedure

WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the 2 covers (1).
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Airbag Bolt (1) - Remove [2x]
Release the connector position assurance (CPA) retainer.
Disconnect the electrical connector.
Steering Wheel Airbag (2) - Remove
Inflatable Restraint Module Handling and Scrapping
Courtesy of GENERAL MOTORS COMPANY

Loosen the steering wheel bolt (1) so that 2 - 3 threads are engaged.
Disconnect the electrical connector.
Wiggle the steering wheel until the wheel disengages completely.
Steering Wheel Bolt (1) - Remove
Steering Wheel (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Shroud Bolt (1) - Remove [6x]
Steering Wheel Shroud (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Radio Favorites Switch (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Cruise Control Switch Assembly (1) @ Steering Wheel - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Bolt (1) @ Cruise Control Switch - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Trim Spoke Cover Applique (1) - Left Side @ Cruise Control Switch (2) - Remove