Cruise Control Switch
Remove switch from steering wheel as described in CRUISE CONTROL SWITCH R & I under REMOVAL & INSTALLATION. Disconnect 4-wire connector at clockspring. Using an ohmmeter, check for continuity between connector wires. See Fig 1 . Compare results obtained with CRUISE CONTROL SWITCH TEST . If switch does not operate properly in all tests, switch is defective.
CRUISE CONTROL SWITCH TEST
| Switch Position | Continuity Between Terminals No. |
|---|---|
| OFF | 1 & 4 |
| ON | 1 & 4 |
| " | 1 & 2 |
| " | 2 & 4 |
| SET | 1 & 2 |
| RESUME | 1 & 3 |