Test 56D - All Taillights Out
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- Turn ignition off. Using DRB-II in ohmmeter mode, check resistance on terminal "R" (Black/Yellow wire) of headlight switch 9-pin connector. If vehicle is equipped with vehicle theft alarm module, disconnect module. See Figure .
- If resistance is more than 5 ohms, replace vehicle theft alarm module. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, repair short to ground in Black/Yellow wire. Perform VERIFICATION PROCEDURE VER-1.
NOTE:
If vehicle is not equipped with vehicle theft alarm module, repair short to ground in Black/Yellow wire. Perform VERIFICATION PROCEDURE VER-1.