Motor Test
Remove power seat switch. Disconnect wiring harness connector. Check harness connector terminal No. 5 for battery voltage and terminal No. 1 for a good ground. Connect a jumper wire between positive battery terminal and specified terminal of power seat motor connector. See MOTOR TEST TERMINALS table. See Fig 1 . Connect another jumper wire between ground and specified terminal of power seat motor connector.
MOTOR TEST TERMINALS
| Apply Battery To Pin No. | Ground Pin No. | Seat Action |
|---|---|---|
| 9 | 6 | Front Up |
| 6 | 9 | Front Down |
| 10 | 3 | Forward |
| 3 | 10 | Backward |
| 8 | 7 | Rear Up |
| 7 | 8 | Rear Down |
| 4 | 2 | Recliner Up |
| 2 | 4 | Recliner Down |