Test 61A - Right BRAKELAMP Out

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS - 3.0L article in ENGINE PERFORMANCE. Perform TEST VER-1 after each repair.

Disconnect lamp outage module 14-pin connector. Check, clean and repair connections as needed. Using scan tool in voltmeter mode, check voltage on lamp outage module 14-pin connector terminal No. 8 (White/Tan wire). Press brake pedal. If voltage is more than 10 volts, replace lamp outage module. If voltage is less than 10 volts, repair open White/Tan wire between lamp outage module connector and right brakelamp switch connector.