Cruise Control Switch: Testing and Inspection

1. Remove ON/OFF and CANCEL speed control switch assembly and disconnect connector.
2. Using a suitable ohmmeter, ensure there is no continuity between switch terminals. Press the CANCEL button and ohmmeter should read 0-0.5 ohms. Press the ON/OFF button and ohmmeter should read 644-668 ohms. If resistance does not fall within these values, replace switch.
3. Remove SET/RESUME speed control switch assembly and disconnect connector.
4. Using a suitable ohmmeter, ensure there is no continuity between switch terminals. Press the SET button and ohmmeter should read 1978-2022 ohms. Press the RESUME button and ohmmeter should read 5558-5682 ohms.