Brake Switch
WARNING: This page is about a different variant/trim than selected.
Disconnect brake switch 6-pin connector. Using an ohmmeter, check for continuity at brake switch. See Fig 1 . If continuity is not as specified in BRAKE SWITCH CONTINUITY table, check brake switch adjustment. If brake switch adjustment is okay, replace defective brake switch.
BRAKE SWITCH CONTINUITY
| Switch Plunger Position | Check Between Terminals No. | Continuity |
|---|---|---|
| Released | 1 & 4 | Yes |
| Released | 2 & 3 | No |
| Depressed | 1 & 4 | No |
| Depressed | 2 & 3 | Yes |