LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1999 >> 300M >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation (Neon)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (Neon)

  1. Powertrain Control Module (PCM) is located at driver's side front corner of engine compartment, near battery and power distribution center. See Fig 3.
  2. Disconnect negative battery cable. Remove filler neck from windshield washer fluid bottle. Squeeze retaining tabs on power distribution center while pulling power distribution center upward from retaining bracket. Lay power distribution center aside for access to PCM.
  3. Remove PCM retaining screws and pull PCM upward. Disconnect electrical connectors from PCM. Remove PCM. To install, reverse removal procedure. Tighten PCM retaining screws to specification. See TORQUE SPECIFICATIONS .
Fig 1: Locating PCM (Breeze, Cirrus, Sebring Convertible & Stratus)
G98B00034Courtesy of CHRYSLER CORP.
Fig 2: Locating PCM (Concorde, Intrepid, LHS & 300M)
G98E00035Courtesy of CHRYSLER CORP.
Fig 3: Locating PCM (Neon)
G98I00037Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals