LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Door System - Front) >> Trim Panel >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Trim Panel: Installation

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place door trim panel in position.
  2. Install wire harness clips into door trim panel.
  3. Connect the courtesy lamp, if equipped.
  4. Connect the radio speaker wire connector.
  5. Connect the power window switch wire connector.
  6. Connect the power door lock switch wire connector.
  7. Connect the power mirror switch wire connector.
  8. Connect the linkage to the handle assembly.
  9. Hook door trim panel over the sheet metal flange.
  10. Insert the forward four way alignment guide into position. Insert the rearward two way alignment guide into position.
  11. Engage rear retaining clips to attach door trim panel to inner sheet metal panel, up to three ratchet clicks.
  12. Install three screws in the speaker area.
  13. Install two screws in the instrument panel interface area.
  14. Install screw in the remote bezel, and close trim plug.
  15. Install screw in pull cup, and close trim plug.
  16. Install three screws to the bottom of the door. Tighten all screws to 1.3 to 1.9 N.m (12 to 17 in. lbs.) torque.
  17. Place speaker grille in position on trim panel.
scientia non olet · About LEMON Manuals