Blower Motor Resistor Block: Installation
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Install the blower motor resistor in the HVAC housing.
- Install the two screws that secure the blower motor resistor to the HVAC housing and tighten to 2.2 N.m (20 in. lbs.).
- Plug in the harness connector to the blower motor resistor.
- Install the lower right underpanel silencer/duct.
- Connect the negative battery cable remote terminal to the remote battery post.