Evaporator Temperature Sensor: Installation
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
The new probe must not go into the same hole (in the evaporator coil) that the old probe was removed.
- The evaporator is manufactured with three holes for probe insertion. Insert the probe in the uppermost hole.
- Insert the access plate inside the HVAC housing and orientate it so that the locking tab is one- quarter turn clockwise to where the tab snaps into the HVAC case detent. Note that the plate will be flush with the outside of the HVAC housing.
- Turn the plate one-quarter turn counter clockwise to seat the locking tab in the HVAC case detent.
- Connect the wiring harness connector for the evaporator probe.
- Install the right under panel silencer.
- Connect the negative battery cable remote terminal to the remote battery post.