Remote Keyless Entry Module: Installation

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

Place module into position on BCM and snap the RKE Module into place.
Attach the junction block/BCM and install the four retaining screws.
Connect battery negative cable.

Install the BCM. Refer to ELECTRONIC CONTROL MODULES .

NOTE: The RKE transmitters must be reprogrammed to the new RKE module.