LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Instrument Cluster) >> Instrument Cluster >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Instrument Cluster: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Tilt steering wheel down to gain access for instrument cluster installation.
  1. Install the instrument cluster into instrument panel. The instrument panel wiring harness connectors are self-aligning, mounted directly to the rear panel. A force of approximately 9 kilograms (30 lbs.) will be required to engage the cluster to the connectors and upper clips.
  2. Install the instrument cluster screws.
  3. Connect headlamp switch connector. Place the cluster bezel into position and snap it into place firmly.
  4. Install the two screws over upper cluster bezel in instrument panel brow area and all remaining attaching screws (four on Intrepid, Limited, and 300M, and five on Concorde).
  5. Install the items covering the bezel mounting screws.
  6. Install the one screw (Limited/300M) to cluster bezel.
  7. Tilt the steering column down into the lowest position.
  8. Install the steering column shroud cover.
  9. Install the instrument panel left end cap.
  10. Connect the negative battery cable remote terminal to the remote battery post.
scientia non olet · About LEMON Manuals