LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Neon LX, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> System Tests >> Brake Switch Operation >> Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Switch Operation: Testing

  1. Turn ignition on. While monitoring scan tool, press brake pedal several times. If scan tool displays brake pedal PRESSED and RELEASED, go to next step. If scan tool does not display brake pedal PRESSED and RELEASED, go to BRAKE SWITCH SENSE STATUS DOES NOT CHANGE ON SCAN TOOL .
    NOTE: Ensure all speed control DTCs are repaired before proceeding.
  2. Start engine. Turn Speed Control (S/C) switch on. Using test light connected to ground, backprobe brake switch connector terminal No. 4 (Dark Blue/Red wire). Press and release brake pedal. If test light is on when brake pedal is released and off when brake pedal is pressed, go to next step. If test light is not on when brake pedal is released or on when brake pedal is pressed, replace brake switch. See BRAKE SWITCH  under REMOVAL & INSTALLATION. Perform TEST VER-4A  under VERIFICATION TESTS.
  3. Turn ignition off. Using test light connected to ground, backprobe brake switch connector terminal No. 6 (Pink/Dark Blue wire). If test light is on, go to next step. If test light is not on, repair open in Pink/Dark Blue wire between brake switch and fuse block. Perform TEST VER-2A  under VERIFICATION TESTS.
  4. Using test light connected to ground, backprobe brake switch connector terminal No. 5 (White/Tan wire). Press brake pedal. If test light is on, test is complete. If test light is not on, replace brake switch. See BRAKE SWITCH  under REMOVAL & INSTALLATION. Perform TEST VER-2A  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals