LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Controls - Basic Diagnostic Procedures) >> Programming >> Sentry Key Immobilizer Module >> Programming SKIM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming SKIM

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scan tool to Data Link Connector (DLC), located under left side of instrument panel. See Figure . Using scan tool, select THEFT ALARM, SKIM then MISC. Select PCM REPLACED. Obtain 4-digit Personal Identification Number (PIN) from vehicle owner or manufacturer.
    CAUTION: Enter correct country code in SKIM. If incorrect country code is entered, SKIM must be replaced.
    NOTE: If 3 attempts are made incorrectly to enter PIN, secured access mode will be locked out for one hour. To exit lock out mode, leave ignition switch in ON position for one hour. Ensure battery voltage is maintained with battery charger, if necessary.
  2. Enter secured access mode by entering PIN code for vehicle. Select COUNTRY CODE. Enter correct country. Select YES to update VIN. SKIM will learn VIN from Powertrain Control Module (PCM). Press ENTER to transfer secret key data from PCM to SKIM. Program ignition keys to SKIM.
scientia non olet · About LEMON Manuals