LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Instrument Cluster Systems >> Cruise Engaged Indicator Not Operating Properly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cruise Engaged Indicator Not Operating Properly

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Perform self-test on instrument cluster. Press and hold TRIP/RESET button and turn ignition on. If cruise indicator does not turn on for 4 seconds then turn off, go to step  3 . If cruise indicator turns on, go to next step.
  2. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Turn ignition on. Using scan tool, check for DTCs. If any DTCs are present, diagnose and repair DTCs before continuing. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM. If no DTCs are present, go to next step.
  3. Start engine and test drive vehicle. Activate cruise control system during test drive. If cruise control system is inoperative, diagnose by symptom. See CRUISE CONTROL SYSTEMS - SEBRING CONVERTIBLE, SEBRING SEDAN & STRATUS SEDAN article. If cruise control system operates properly, go to next step.
  4. Turn ignition off. Remove and disconnect instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Remove and inspect cruise indicator bulb and socket. Replace as necessary. If cruise indicator bulb and socket are okay, diagnose PCI communications system. See BUS +/- SIGNALS OPEN OR NO RESPONSE FROM INSTRUMENT CLUSTER  under COMMUNICATIONS. If bus circuit is okay, replace instrument cluster.
scientia non olet · About LEMON Manuals