Power Circuit
NOTE:
For additional testing and diagnostics, see POWER TOP SYSTEM (SEBRING CONVERTIBLE) in BODY CONTROL MODULES - SEBRING CONVERTIBLE, SEBRING SEDAN & STRATUS SEDAN article.
Remove driver's door trim panel. See DOOR TRIM PANEL under REMOVAL & INSTALLATION. Disconnect driver's power window switch connector. Turn ignition on. Using DVOM, measure voltage between terminal No. 1 (Tan wire) and terminal No. 10 (Black wire) at power window harness connector. See Fig 1 . If battery voltage is present, test power window switch. See WINDOW SWITCH under COMPONENT TESTS. If battery voltage is not present, check circuit breaker No. 2 (30-amp) located in junction block located on left end of instrument panel. Repair as necessary. If circuit breaker is okay, check for an open circuit between ignition switch and power window switch connector.