LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> PT Cruiser Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Control Modules) >> Verification Tests >> Anti-Lock Brake System Verification Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Anti-Lock Brake System Verification Test

WARNING: This page is about a different car, the 2002 Dodge Ram Wagon, 2002 Dodge Ram Van, 2001 Dodge Ram Wagon, and 2001 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Disconnect any previously connected jumper wires and tools. Reconnect any previously disconnected components and connectors. Ensure all accessories are turned off and that battery is fully charged. Turn ignition on.
  2. Connect scan tool to Data Link Connector (DLC). Using scan tool with most current scan tool software available, clear Diagnostic Trouble Codes (DTC) from all modules. Start engine, allowing it to run for 2 minutes and fully operate the malfunctioning system.
  3. Turn ignition off and wait 5 seconds. Turn ignition on. Using scan tool, read DTCs from all modules. If no DTCs are present, go to next step. If any DTCs are present, go to DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM and perform corresponding test(s).
  4. Ensure braking capability is available and road test vehicle a minimum of 5 minutes, performing several anti-lock braking stops. Using scan tool, read DTCs from all modules. If no DTCs are present, repair is complete. If any DTCs are present, go to DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM and perform corresponding test(s).
scientia non olet · About LEMON Manuals