LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> PT Cruiser Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Control Modules) >> Verification Tests >> Body Verification Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Verification Test

WARNING: This page is about a different car, the 2002 Dodge Ram Wagon, 2002 Dodge Ram Van, 2001 Dodge Ram Wagon, and 2001 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect any previously connected jumper wires and tools. Reconnect any previously disconnected components and connectors. If Central Timer Module (CTM) has been replaced, turn ignition on for 15 seconds. Connect scan tool to Data Link Connector (DLC).
  2. Using scan tool with most current software available, enable Vehicle Theft Security System (VTSS), program all RKE transmitters and program other options as necessary. Ensure all accessories are turned off and that battery is fully charged.
  3. Using scan tool, clear Diagnostic Trouble Codes (DTC) from all modules. Start engine, allowing it to run for 2 minutes and fully operate the malfunctioning system. Turn ignition off and wait 5 seconds. Turn ignition on. Using scan tool read DTCs from all modules.
  4. If any DTCs are present, go to DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM and perform corresponding test(s).
  5. If no DTCs are present but customer complaint can be duplicated, go to SYMPTOM IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM and repair by symptom. If no DTCs are present and customer complaint cannot be duplicated, repair is complete.
scientia non olet · About LEMON Manuals