Side Impact Airbag Control Module

SIDE IMPACT AIRBAG CONTROL MODULE

REMOVAL
1. Disconnect and isolate the battery negative cable remote terminal.
2. Remove the lower B-pillar trim from the appropriate side of the vehicle. Refer to Body, Interior, B-Pillar Lower Trim, Removal.
3. Disconnect the side impact airbag control module electrical connector.
4. Remove the SIACM retaining screws and remove the module from the vehicle.

INSTALLATION
1. Position the SIACM in B-pillar and install the retaining screws. Torque the screws to 10 Nm (85 in. lbs.).
2. Connect the SIACM electrical connector.
3. Install the lower B-pillar trim. Refer to Body Interior, B-Pillar Lower Trim, Installation.

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE REMOTE TERMINAL. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND TESTING - AIRBAG SYSTEM FIRST.