LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2004 >> PT Cruiser Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Rear Wheel Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Wheel Speed Sensor: Removal

NOTE: Before proceeding, (Refer to WARNING inDISC & DRUM ) and CAUTION  .
  1. Raise the vehicle.
  2. Remove the tire and wheel assembly from the vehicle.
  3. Disconnect the wheel speed sensor cable connector from the vehicle wiring harness (Fig 1 ). Remove the clip attaching wheel speed sensor cable connector to the vehicle's body.
    Fig 1: Identifying Wheel Speed Sensor Connector
    G03526987Courtesy of DAIMLERCHRYSLER CORP.
  4. Disconnect the wheel speed sensor cable routing clips running along the brake tube, brake hose and axle trailing arm.
    CAUTION: When removing a wheel speed sensor from the rear disc brake adapter, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.
  5. Remove the bolt attaching the wheel speed sensor to the rear disc brake adapter or drum brake support plate (Fig 2 ), then carefully remove the sensor head from the rear disc brake adapter and vehicle.
    Fig 2: Identifying Right Rear Wheel Speed Sensor
    G03526988Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals