Controller Antilock Brake: Installation

Connect 47-way wiring connector at CAB (Fig 1).
Align CAB solenoids and pump/motor wiring connector with HCU valves and connector passage (Fig 2). Slide CAB onto HCU.

Fig 1: Connecting 47-Way Wiring Connector At CAB
Courtesy of DAIMLERCHRYSLER CORP.

Fig 2: Connecting CAB To HCU
Courtesy of DAIMLERCHRYSLER CORP.
Install 3 screws mounting CAB to HCU (Figure). Tighten CAB mounting screws to 2 N.m (17 in. lbs.) torque.
Lower vehicle.
Connect negative battery cable to battery post.
Hook up DRBIII® to initialize CAB. Check and clear any faults.