LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module-Antilock Brake >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module-Antilock Brake: Removal

Fig 1: LX BATTERY AND CABLES
GC0012970Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative (-) battery cable (2) from battery post and isolate.
    Fig 2: REAR TUBES AND CONNECTOR AT ICU
    GC0014657Courtesy of DAIMLERCHRYSLER CORP.
  2. Disconnect 47-Way wiring connector (4) at ABM (6).
    Fig 3: ICU AND BRAKE TUBES
    GC0014656Courtesy of DAIMLERCHRYSLER CORP.
  3. Unclip brake tubes (1, 2 and 10) from two routing clips (6) along upper radiator support.
  4. Unclip brake tube (3) from routing clip (4) below Fuse And Relay Center.
  5. Lift up on entire assembly (5) from mounting grommets (8) and move inboard allowing access to ABM attaching screws. Do not force brake tubes. Move assembly just enough to access mounting screws. 
    Fig 4: ABM ATTACHING SCREWS
    GC0014658Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove three screws (2) attaching ABM (1).
    Fig 5: ABM REMOVAL/INSTALLATION
    GC0014659Courtesy of DAIMLERCHRYSLER CORP.
  7. Slide ABM (1) off HCU (3).
scientia non olet · About LEMON Manuals