Module-Sentry Key Immobilizer: Removal
WARNING: This page is about a different car, the 2005 Dodge Pickup and 2005 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
- Disconnect and isolate the battery negative cable.
- Grasp the tilt steering column knob (2) firmly and pull it straight rearward to remove it from the tilt adjuster lever (1) on the left side of the column.
- From below the steering column, remove the two outboard screws that secure the upper column shroud (1) to the lower shroud (3).
- Using hand pressure, push inward on both sides of the upper shroud above the parting line of the lower shroud to release the snap features that secure the two shroud halves to each other.
- Remove the upper shroud from the lower shroud and the steering column.
- Remove the one center screw that secures the lower shroud to the steering column (4).
- Remove the lower shroud from the steering column.
- Disconnect the wire harness connector (2) from the Sentry Key Immobilizer Module (SKIM) (1).
- Remove the screw (3) that secures the SKIM (1) to the steering column (2).
- Disengage the antenna ring from around the ignition lock cylinder housing and remove the SKIM.