3.7L/4.7L Gas
WARNING: This page is about a different car, the 2005 Dodge Pickup and 2005 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Install end of cable to speed control servo. Refer to Removal/Installation in SERVO .
- Slide speed control cable plastic mount into throttle body bracket.
- Install speed control cable connector onto throttle body bellcrank pin (push rearward to snap into location).
- Slide throttle (accelerator) cable plastic mount into throttle body bracket. Continue sliding until cable release tab is aligned to hole in throttle body mounting bracket.
- While holding throttle to wide open position, place throttle cable pin into throttle body bellcrank.
- Install air intake tube to top of throttle body.
- Connect negative battery cable at battery.
- Before starting engine, operate accelerator pedal to check for any binding.