Module-Anti-Lock Brakes: Installation

WARNING: This page is about a different car, the 2005 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type, refer to DIFFERENTIAL & DRIVELINE . For tire revolutions per mile (Refer to TIRES/WHEELS/TIRES - SPECIFICATIONS) . To program the ABM, refer to ABS - SERVICE INFORMATION .

Fig 1: HYDRAULIC CONTROL UNIT

Courtesy of DAIMLERCHRYSLER CORP.

Position the module (1) on the HCU (2).

Fig 2: ANTI-LOCK BRAKES MODULE
Courtesy of DAIMLERCHRYSLER CORP.
Install the mounting screws (1) and tighten to 6 N.m (53 in. lbs).
Install the pump electrical connector (3) to the module (4).
Install the HCU to the vehicle (Refer to BRAKES/HYDRAULIC/MECHANICAL/HCU (HYDRAULIC CONTROL UNIT) - INSTALLATION).