Module-Anti-Lock Brakes: Removal

WARNING: This page is about a different car, the 2005 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type, refer to DIFFERENTIAL & DRIVELINE . For tire revolutions per mile, (Refer to TIRES/WHEELS/TIRES - SPECIFICATIONS) . To program the ABM, refer to ABS - SERVICE INFORMATION .

Fig 1: ANTI-LOCK BRAKES MODULE

Courtesy of DAIMLERCHRYSLER CORP.

Remove the HCU from the vehicle (Refer to BRAKES/HYDRAULIC/MECHANICAL/HCU (HYDRAULIC CONTROL UNIT) - REMOVAL).
Remove the module mounting screws (1).
Disconnect the pump electrical connector (3) from the HCU (2).

Fig 2: HYDRAULIC CONTROL UNIT
Courtesy of DAIMLERCHRYSLER CORP.
Remove the module (1) from the HCU (2).