With APPS

WARNING: This page is about a different car, the 2005 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: ACCELERATOR PEDAL W/APPS

Courtesy of DAIMLERCHRYSLER CORP.

The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles equipped with an accelerator pedal position sensor (6).

The accelerator pedal is serviced as a complete assembly including the bracket.

Place accelerator pedal assembly (4) over two mounting studs (3).
Install and tighten two mounting nuts (5). Refer to TORQUE - FUEL SYSTEM .
Install electrical connector (1) to APPS (6).
A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from PCM.
Before starting engine, operate accelerator pedal to check for any binding.