Servo-Speed Control: Removal

WARNING: This page is about a different car, the 2005 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: SPEED CONTROL SERVO LOCATION

Courtesy of DAIMLERCHRYSLER CORP.

The speed control servo assembly (4) is attached to the bottom of the PDC (Power Distribution Center) (1).

Disconnect negative battery cable at battery.
Disconnect vacuum line at servo.
Disconnect electrical connector (3) at servo.
Remove three servo mounting screws (2).
Disconnect servo cable at throttle body. Refer to REMOVAL .

Fig 2: SERVO CABLE CLIP REMOVE/INSTALL - TYPICAL
Courtesy of DAIMLERCHRYSLER CORP.
Remove 2 mounting nuts (1) holding servo cable sleeve (4) to bracket.
Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (3) and remove clip. Note: The servo mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
Remove servo (2) from mounting bracket. While removing, note orientation of servo to bracket.