LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Power Steering System) >> Drag Link >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Drag Link: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drag link to the pitman arm. Install the nut and tighten to 88 N.m (65 ft. lbs.).
  2. Install the drag link to the right steering knuckle. Install the nut and tighten to 108 N.m (80 ft. lbs.).
  3. Install tie rod to the left steering knuckle and drag link. Install the nuts and tighten to 108 N.m (80 ft. lbs.).
  4. Remove the supports and lower the vehicle to the surface. Center steering wheel and adjust toe, (Refer to SPECIFICATIONS & PROCEDURES ).
  5. After adjustment tighten tie rod adjustment sleeve clamp bolts to 61 N.m (45 ft. lbs.).
NOTE: Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.
scientia non olet · About LEMON Manuals