Steering Column Control Module: Assembly

Fig 1: MULTIFUNC FROM CIRCUIT BOARD

Courtesy of DAIMLERCHRYSLER CORP.

Position the Steering Column Control Module (SCCM) circuit board onto the multi-function switch.

Fig 2: MULTIFUNC REAR
Courtesy of DAIMLERCHRYSLER CORP.
Install the multi-function switch and circuit board and tighten the three screws (1) from the bottom of the SCCM.

Fig 3: SCCM STALKS
Courtesy of DAIMLERCHRYSLER CORP.
Install the steering column telescoping lever (3).

Fig 4: SPEED CONTROL FROM SCCM
Courtesy of DAIMLERCHRYSLER CORP.
Install the speed control switch (1).

Fig 5: STRUT UNDEDER ESP
Courtesy of DAIMLERCHRYSLER CORP.
If equipped with manual telescoping column Install the strut (1).

Fig 6: SCCM STALKS
Courtesy of DAIMLERCHRYSLER CORP.
If equipped with electronic telescoping column , install the electric tilt lever and switch (3).

Fig 7: STEERING ANGLE SENSOR SCREW
Courtesy of DAIMLERCHRYSLER CORP.
If equipped wit ESP Install the steering angle sensor and screw (3) located at the six o'clock position.

Fig 8: CLOCKSPRING SCREWS
Courtesy of DAIMLERCHRYSLER CORP.
Install the clockspring and screws (1).
If equipped with ESP Recalibrate the steering angle sensor using the scan tool.