Standard Procedure - Quick Learn Procedure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The quick learn procedure requires the use of the scan tool. This program allows the electronic transaxle system to recalibrate itself. This will provide the best possible transaxle operation.

NOTE: The quick learn procedure should be performed if any of the following procedures are performed:

Transaxle Assembly Replacement
Powertrain Control Module Replacement
Solenoid/Pressure Switch Assembly Replacement
Clutch Plate and/or Seal Replacement
Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

The brakes must be applied
The engine speed must be above 500 RPM
The throttle angle (TPS) must be less than 3 degrees
The shift lever position must stay until prompted to shift to overdrive
The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the scan tool indicates the procedure is complete
The calculated oil temperature must be above 60° and below 200°

Plug the scan tool into the diagnostic connector. The connector is located under the instrument panel.
Go to the Transmission screen.
Go to the Miscellaneous screen.
Select Quick Learn Procedure. Follow the instructions of the scan tool to perform the Quick Learn Procedure.