LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Electronic Control Modules - Except Coupe) >> Sentry Key Immobilizer Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sentry Key Immobilizer Module: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the SKIM is replaced with a new unit, a scan tool MUST be used to initialize the new SKIM and to program at least two Sentry Key transponders. (Refer to STANDARD PROCEDURE - TRANSPONDER PROGRAMMING ) Sentry Key Immobilizer Module Initialization.
  2. Carefully position the SKIM, the mounting bracket and the antenna ring onto the steering column.
  3. Install the two retaining screws. See Figure.
  4. Connect the wire harness connector.
  5. Install the steering column upper and lower shrouds.
  6. Install the knee bolster (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL ASSEMBLY - INSTALLATION) .
  7. Connect the battery negative remote cable.
scientia non olet · About LEMON Manuals