Section 125 (Speed Control): Switch: Installation
WARNING: This page is about a different car, the 2005 Dodge SX, 2005 Dodge SRT-4, and 2005 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module. See Figure.
WARNING:
IF REMOVAL OF AIRBAG MODULE IS NECESSARY, REFER TO THE RESTRAINTS
.
- Connect the electrical connector.
- Install switch and tighten the screws to 1.6 N.m (15 ins. lbs.). Make sure rubber seal is in place around switch. See Figure.
- Install airbag, refer to the RESTRAINTS .
- Install the negative battery cable.
- Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.