Hard Wired Inputs
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
The hard wired inputs to the BCM include the following:
- A/C on/off control
- BCM flash enable
- Door lock switch mux
- Driver door ajar switch sense
- Flip-up glass ajar switch sense
- Flip-up glass release switch sense
- Front fog lamp switch sense
- Front wiper park switch sense
- Front wiper switch mux
- Fused B(+)
- Fused ignition switch output (run-acc)
- Fused ignition switch output (run-start)
- Headlamp switch mux
- High beam switch sense
- Hood ajar switch sense - with VTSS - in markets where required only
- Key-in ignition switch sense
- Left rear door ajar switch sense
- Lightbar switch sense - Renegade with light bar only
- Panel lamps dimmer switch mux
- Passenger front door ajar switch sense
- Radio control mux - with remote radio switches only
- Rear courtesy lamp control
- Rear window defogger control
- Rear wiper intermittent driver
- Rear wiper on driver
- RHD input - connected to ground on right-hand drive models only
- Right rear door ajar switch sense
- Tailgate ajar switch sense
- Washer pump driver
- Vehicle speed signal
Refer to SYSTEM WIRING DIAGRAMS for additional details.