LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Electronic Control Modules) >> Sentry Key Immobilizer Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sentry Key Immobilizer Module: Installation

WARNING: This page is about a different car, the 2005 Dodge SX, 2005 Dodge SRT-4, and 2005 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the SKIM is replaced with a new unit, a DRB lll® scan tool MUST be used to initialize the new SKIM and to program at least two Sentry Key transponders (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/SENTRY KEY IMMOBILIZER MODULE - STANDARD PROCEDURE) .
  1. Place the SKIM into position.
  2. Rotate the SKIM and its mounting bracket downwards and then to the side towards the steering column. See Figure.
  3. Install the two screws securing the SKIM to the top of the steering column. See Figure.
  4. Engage the steering column wire harness to the Sentry Key Immobilizer Module (SKIM). See Figure.
  5. Install the steering column upper and lower shrouds. Refer to Steering, Column, Column Shroud, Installation.
  6. Install the Lower Instrument Panel Cover. Refer to Body, Instrument Panel, Lower Instrument Panel Cover, Installation.
  7. Connect the battery negative cable.
scientia non olet · About LEMON Manuals