LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Electronic Control Modules) >> Power Liftgate Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Liftgate Control Module: Installation

WARNING: This page is about a different car, the 2005 Dodge Grand Caravan, 2005 Dodge Caravan, and 2005 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the Power Liftgate (PLG) control module on the D-pillar and install retaining screw.
  2. Connect the wire harness connections to the PLG control module. Be certain to slide connector locks to the locked position.
  3. Install the D-pillar trim panel on the vehicle. (Refer to BODY/INTERIOR/LEFT D-PILLAR TRIM PANEL - INSTALLATION)
  4. Connect the battery negative cable.
  5. Using an appropriate scan tool, check and erase any PLG control module diagnostic trouble codes.
  6. Verify PLG system operation. Cycle the PLG through one complete open and close cycle, this will allow the PLG control module to relearn its cycle with the new components.
scientia non olet · About LEMON Manuals