Sensor-Steering Angle: Installation

Fig 1: Steering Angle Sensor

Courtesy of DAIMLERCHRYSLER CORP.

Install the steering angle sensor (1) to the SCCM (2).

Fig 2: Steering Angle Sensor Screw
Courtesy of DAIMLERCHRYSLER CORP.
Tighten the screws securing the steering angle sensor (3) to the SCCM.

Fig 3: Clockspring Screws
Courtesy of DAIMLERCHRYSLER CORP.
Install the clockspring and tighten the screws (1). (Refer to CLOCKSPRING )

Fig 4: Removing/Installing Steering Wheel
Courtesy of DAIMLERCHRYSLER CORP.
Align the spline on the steering wheel hub to the steering column shaft.
Slide the steering wheel (1) onto the shaft and install a new mounting bolt (2). Tighten the bolt to 61 N.m (45 ft. lbs.).

Fig 5: Removing/Installing Driver Airbag
Courtesy of DAIMLERCHRYSLER CORP.
Install the airbag (3) on the steering wheel (1). (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION)

Fig 6: Disconnecting/Connecting Battery Cables
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery negative cable (2) to battery post. It is important that this is performed properly. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE)
Perform Verification Test and clear any faults. (Refer to BRAKES - DIAGNOSIS AND TESTING)
Test the operation of the horn, lights and any other functions that are steering column operated.