Module-Steering Column Control: Assembly

Fig 1: Multi-Function From Circuit Board

Courtesy of DAIMLERCHRYSLER CORP.

Position the Steering Control Module (SCM) onto the multi-function switch.

Fig 2: Multi-Function Switch Rear
Courtesy of DAIMLERCHRYSLER CORP.
Install the multi-function switch and SCM in the SCCM Shroud and tighten the three screws (1) from the bottom.

Fig 3: Identifying SCCM Components
Courtesy of DAIMLERCHRYSLER CORP.
Install the steering column telescoping lever (3).

Fig 4: Speed Control from SCCM
Courtesy of DAIMLERCHRYSLER CORP.
Install the speed control switch (1).

Fig 5: Installing Strut
Courtesy of DAIMLERCHRYSLER CORP.
If equipped with manual telescoping column , install the strut (1).

Fig 6: Identifying SCCM Components
Courtesy of DAIMLERCHRYSLER CORP.
If equipped with electronic telescoping column , install the electric tilt lever and switch (3).

Fig 7: Steering Angle Sensor Screw
Courtesy of DAIMLERCHRYSLER CORP.
If equipped with ESP , install the steering angle sensor and screw (3) located at the six o'clock position.

Fig 8: Clockspring Screws
Courtesy of DAIMLERCHRYSLER CORP.
Install the clockspring and screws (1) leaving one out so it will not unwind.
Install the SCCM on the steering column, (Refer to STEERING/COLUMN/STEERING COLUMN CONTROL MODULE - INSTALLATION) and tighten the one clockspring screw (1) that was left loose.