LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Powertrain Control Module >> Standard Procedure >> Standard Procedure - Pcm/SKREEM Programming >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Procedure - Pcm/SKREEM Programming: Notes

NOTE: Before replacing the PCM, be sure to check the related component/circuit integrity for failures not detected due to a double fault in the circuit. Most PCM failures are caused by internal component failures (i.e. relays and solenoids) and shorted circuits (i.e. pull-ups, drivers, and switched circuits). These failures are difficult to detect when a double fault has occurred and only one DTC has been set.

When a Powertrain Control Module (PCM) and the Sentry Key Remote Entry Module (SKREEM) are replaced at the same time, perform the following steps:

  1. Using the DRB III® scan tool, follow the on screen instructions to program the new PCM.
  2. Using the DRB III®, follow the on screen instructions to program the new Sentry Key Remote Entry Module.
  3. Replace all ignition keys and program them to the new Sentry Key Remote Entry Module.
scientia non olet · About LEMON Manuals