Multi-Function Switch: Installation
WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.
- The windshield wiper/washer switch must be transferred to the new multi-function switch. WIPER/WASHER SWITCH
- Install the multi-function switch mounting screws. Tighten multi-function switch to column retaining screws to 3 N.m (27 in. lbs.) torque.
- Connect both posi-lock harness connectors at the rear of the multi-function switch.
- Instal both upper and lower steering column shrouds.
- Connect the battery negative cable.
- Place battery access cover into place and install four bolts.
- Close deck lid.
- Verify vehicle and system operation.