LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Electronic Control Modules (Service Information)) >> Controller Antilock Brake >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Controller Antilock Brake: Installation

WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Hydraulic Lines
GC0034997Courtesy of DAIMLERCHRYSLER CORP.
  1. Install the Controller Antilock Brake (CAB) to the Hydraulic Control Unit (HCU) with the retaining screws.
  2. Check the seating and condition of the Integrated Control Unit (ICU) rubber grommets and replace if necessary.
  3. Install the ICU to the retaining bracket with the retaining screws.
    CAUTION: Do not wrongfully connect hydraulic lines. Trace the line routing to the corresponding wheel if necessary.
  4. Install the brake lines (1-6). Pay close attention to the markings when attaching the hydraulic lines.
    Fig 2: Disconnecting/Connecting CAB Harness Connector
    GC0034999Courtesy of DAIMLERCHRYSLER CORP.
  5. Reconnect the CAB harness connector (1).
  6. Connect the negative battery cable.
  7. Bleed the brake system. (Refer to BRAKES - STANDARD PROCEDURE) .
  8. Read the fault memory and erase.
scientia non olet · About LEMON Manuals