LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Electronic Control Modules (Service Information)) >> Transmission Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Module: Installation

WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Transmission Control Module (TCM)
GC0034993Courtesy of DAIMLERCHRYSLER CORP.
  1. Connect the TCM harness connectors and attach the TCM (2) to the base plate with the two retaining screws (1).
    Fig 2: Identifying Retaining Nuts
    GC0034836Courtesy of DAIMLERCHRYSLER CORP.
  2. Rotate the base plate and install it over the mounting studs on the floor panel.
    NOTE: Be sure not to pinch or cause interference with the wiring harnesses while locating the base plate to the floor mounting studs.
  3. Install the three plastic retaining nuts (1) and secure the base plate to the vehicle floor.
    Fig 3: Locating Foam Insulating Panel
    GC0034838Courtesy of DAIMLERCHRYSLER CORP.
  4. Install the foam insulation panel.
    NOTE: Make sure the aligning tabs of the base plate are positioned correctly in the foam insulating panel.
  5. Install the carpeting in the passenger footwell.
  6. Install the floor mat to the carpet.
    Fig 4: Removing/Installing Transmission Control Module (TCM)
    GC0034993Courtesy of DAIMLERCHRYSLER CORP.
  7. Connect the TCM harness connectors and attach the TCM to the base plate with the two retaining screws (1).
    Fig 5: Identifying Retaining Nuts
    GC0034836Courtesy of DAIMLERCHRYSLER CORP.
  8. Rotate the base plate and install it over the mounting studs on the floor panel.
    NOTE: Be sure not to pinch or cause interference with the wiring harnesses while locating the base plate to the floor mounting studs.
  9. Install the three plastic retaining nuts (1) and secure the base plate to the vehicle floor.
    Fig 6: Removing/Installing Foam Insulation Panel
    GC0034995Courtesy of DAIMLERCHRYSLER CORP.
  10. Install the foam insulation panel.
    NOTE: Make sure the aligning tabs of the base plate are positioned correctly in the foam insulating panel.
  11. Install the carpeting in the passenger footwell.
  12. Install the floor mat to the carpet.
scientia non olet · About LEMON Manuals